Não conhecido declarações factuais Cerca de sculptra
Não conhecido declarações factuais Cerca de sculptra
Blog Article
13 Reviews View more Tylenol Tylenol is a pain reliever and a fever reducer used to treat many conditions such as headaches ...
The injection needle should be filled (primed) with approximately 1 mL of reconstituted BOTOX prior to the start of injections (depending on the needle length) to remove any air.
知乎，让每一次点击都充满意义 —— 欢迎来到知乎，发现问题背后的世界。
Delayed-onset inflammation near the sitio of injection is one of the known adverse events associated with dermal fillers. Cases of delayed-onset inflammation have been reported to occur at the treatment site following viral or bacterial illnesses or infections, vaccinations, or dental procedures. Typically, the reported inflammation was responsive to treatment or resolved on its own.
The safe and effective use of BOTOX depends upon proper storage of the product, selection of the correct dose, and proper reconstitution and administration techniques. An understanding of standard electromyographic techniques is also required for treatment of strabismus, upper or lower limb spasticity, and may be useful for the treatment of cervical dystonia.
Repeat injections for hyperhidrosis should be administered when the clinical effect of a previous injection diminishes.
The degree and pattern of muscle spasticity at the time of re-injection may necessitate alterations in the dose of BOTOX and muscles to be injected.
An appropriately sized needle (e.g., 25-30 gauge) may be used for superficial muscles, and a longer 22 gauge needle may be used for deeper musculature. Localization of the involved muscles with techniques such as needle electromyographic guidance, nerve stimulation, or ultrasound is recommended. Repeat BOTOX treatment may be administered when the effect of a previous injection has diminished, but generally no sooner than 12 weeks after the previous injection. The degree and pattern of muscle spasticity radiesse at the time of re-injection may necessitate alterations in the dose of BOTOX and muscles to be injected.
Radiesse stimulates collagen III, which is gradually replaced by collagen I. This creates a stable organized ration of collagen I and II with structure and support, compared to collagen type I stimulation alone.3-5
Subsequent doses for patients experiencing incomplete paralysis of the target muscle may be increased up to two-fold compared to the previously administered dose.
treat overactive bladder symptoms, such as urinary urgency, frequency, or incontinence, in adults when anticholinergics do not work well enough or cannot be taken
Physicians administering BOTOX must understand the relevant neuromuscular and structural anatomy of the area involved and any alterations to the anatomy due to prior surgical procedures and disease, especially when injecting near the lungs.
If a local anesthetic instillation is performed, the bladder should be drained and irrigated with sterile saline before injection.
Reconstituted BOTOX (200 Units/30 mL) is injected into the detrusor muscle via a flexible or rigid cystoscope, avoiding the trigone. The bladder should be instilled with enough saline to achieve adequate visualization for the injections, but over-distension should be avoided. The injection needle should be filled (primed) with approximately 1 mL of reconstituted BOTOX prior to the start of injections (depending on the needle length) to remove any air.